renamed source code and completed iris kit auth procedure

lib/IRremoteESP8266/examples/TurnOnArgoAC/TurnOnArgoAC.ino

@@ -1,58 +0,0 @@
-/* Copyright 2017, 2018 crankyoldgit
-* An IR LED circuit *MUST* be connected to the ESP8266 on a pin
-* as specified by kIrLed below.
-*
-* TL;DR: The IR LED needs to be driven by a transistor for a good result.
-*
-* Suggested circuit:
-*     https://github.com/markszabo/IRremoteESP8266/wiki#ir-sending
-*
-* Common mistakes & tips:
-*   * Don't just connect the IR LED directly to the pin, it won't
-*     have enough current to drive the IR LED effectively.
-*   * Make sure you have the IR LED polarity correct.
-*     See: https://learn.sparkfun.com/tutorials/polarity/diode-and-led-polarity
-*   * Typical digital camera/phones can be used to see if the IR LED is flashed.
-*     Replace the IR LED with a normal LED if you don't have a digital camera
-*     when debugging.
-*   * Avoid using the following pins unless you really know what you are doing:
-*     * Pin 0/D3: Can interfere with the boot/program mode & support circuits.
-*     * Pin 1/TX/TXD0: Any serial transmissions from the ESP8266 will interfere.
-*     * Pin 3/RX/RXD0: Any serial transmissions to the ESP8266 will interfere.
-*   * ESP-01 modules are tricky. We suggest you use a module with more GPIOs
-*     for your first time. e.g. ESP-12 etc.
-*/
-
-#ifndef UNIT_TEST
-#include <Arduino.h>
-#endif
-#include <IRremoteESP8266.h>
-#include <IRsend.h>
-#include <ir_Argo.h>
-
-const uint16_t kIrLed = 4;  // ESP8266 GPIO pin to use. Recommended: 4 (D2).
-IRArgoAC ac(kIrLed);  // Set the GPIO to be used to sending the message.
-
-void setup() {
-  ac.begin();
-  Serial.begin(115200);
-}
-
-void loop() {
-  Serial.println("Sending...");
-
-  // Set up what we want to send. See ir_Argo.cpp for all the options.
-  ac.setPower(true);
-  ac.setFan(kArgoFan1);
-  ac.setCoolMode(kArgoCoolAuto);
-  ac.setTemp(25);
-
-#if SEND_ARGO
-  // Now send the IR signal.
-  ac.send();
-#else  // SEND_ARGO
-  Serial.println("Can't send because SEND_ARGO has been disabled.");
-#endif  // SEND_ARGO
-
-  delay(5000);
-}

lib/IRremoteESP8266/examples/TurnOnArgoAC/platformio.ini

@@ -1,17 +0,0 @@
-[platformio]
-lib_extra_dirs = ../../
-src_dir=.
-
-[common]
-build_flags =
-lib_deps_builtin =
-lib_deps_external =
-
-[env:nodemcuv2]
-platform = espressif8266
-framework = arduino
-board = nodemcuv2
-build_flags = ${common.build_flags}
-lib_deps =
-  ${common.lib_deps_builtin}
-  ${common.lib_deps_external}