renamed source code and completed iris kit auth procedure

lib/IRremoteESP8266/examples/IRrecvDemo/IRrecvDemo.ino

@@ -1,52 +0,0 @@
-/*
- * IRremoteESP8266: IRrecvDemo - demonstrates receiving IR codes with IRrecv
- * This is very simple teaching code to show you how to use the library.
- * If you are trying to decode your Infra-Red remote(s) for later replay,
- * use the IRrecvDumpV2.ino example code instead of this.
- * An IR detector/demodulator must be connected to the input kRecvPin.
- * Copyright 2009 Ken Shirriff, http://arcfn.com
- * Example circuit diagram:
- *  https://github.com/markszabo/IRremoteESP8266/wiki#ir-receiving
- * Changes:
- *   Version 0.2 June, 2017
- *     Changed GPIO pin to the same as other examples.
- *     Used our own method for printing a uint64_t.
- *     Changed the baud rate to 115200.
- *   Version 0.1 Sept, 2015
- *     Based on Ken Shirriff's IrsendDemo Version 0.1 July, 2009
- */
-
-#ifndef UNIT_TEST
-#include <Arduino.h>
-#endif
-#include <IRremoteESP8266.h>
-#include <IRrecv.h>
-#include <IRutils.h>
-
-// An IR detector/demodulator is connected to GPIO pin 14(D5 on a NodeMCU
-// board).
-const uint16_t kRecvPin = 14;
-
-IRrecv irrecv(kRecvPin);
-
-decode_results results;
-
-void setup() {
-  Serial.begin(115200);
-  irrecv.enableIRIn();  // Start the receiver
-  while (!Serial)  // Wait for the serial connection to be establised.
-    delay(50);
-  Serial.println();
-  Serial.print("IRrecvDemo is now running and waiting for IR message on Pin ");
-  Serial.println(kRecvPin);
-}
-
-void loop() {
-  if (irrecv.decode(&results)) {
-    // print() & println() can't handle printing long longs. (uint64_t)
-    serialPrintUint64(results.value, HEX);
-    Serial.println("");
-    irrecv.resume();  // Receive the next value
-  }
-  delay(100);
-}

lib/IRremoteESP8266/examples/IRrecvDemo/platformio.ini

@@ -1,17 +0,0 @@
-[platformio]
-lib_extra_dirs = ../../
-src_dir=.
-
-[common]
-build_flags =
-lib_deps_builtin =
-lib_deps_external =
-
-[env:nodemcuv2]
-platform = espressif8266
-framework = arduino
-board = nodemcuv2
-build_flags = ${common.build_flags}
-lib_deps =
-  ${common.lib_deps_builtin}
-  ${common.lib_deps_external}